| 1 | Operating Temperature Range | Preservative Temperature Range | -20C ~ 70C | 15C ~ 35C |
| 3A | Contact Resistance | Measured by the contact resistance apparatus or meter at 0.1A DC5V. The result is the average of 5 successive measurements. | 70m max |
| 3B | Insulation Resistance | A voltage of 250V DC shall be applied for 1 min. after which measurement shall be made. Between terminals and between individual terminals and frame. | 100M min |
| 3C | Dielectric Strength | A voltage of 250V AC shall be applied for 1 min. after which measurement shall be made. Between terminals and between individual terminals and frame. | 250V AC 1 min. (No damage, arcing, or breakdown) |
| 4A | Insertion and Withdraw Force | Measured at across spring piece and across matching plug for ergometer. | 3-40 N |
| 4B | Terminal Strength | A static load of 10 N (1000gf) shall be applied to the tip of the terminals for 60 sec. in any direction of actuator. | Without damage or excessive looseness |
| 4C | Atmospheric Conditions for Measurements | Ambient Temperature: 15C to 35C; Relative Humidity: 25% to 75% RH; Air Pressure: 80Kpa to 106Kpa | Standard conditions met |
| 5A | Soldering | Wave-soldering: within 3 seconds at 260 5C. Hand welding: within 3 seconds at 380C or below. | Electrical characteristics shall be satisfied. |
| 5B | Life Test | Actuator subjected to 5000 cycles at a speed of 30 cycles/min. | Contact resistance 200m. Electrical characteristics shall be satisfied. |
| 5C | Heat Test | 852C for 48 hours, then keep in normal condition for 30 minutes. | No damage on appearance. Mechanical and electrical characteristics shall be satisfied. |
| 5D | Humidity Test | 402C, 90-96% RH for 48 hours, then keep in normal condition for 30 minutes. | Mechanical and electrical characteristics shall be satisfied. |
| 5E | Cold Test | -402C for 48 hours, then keep in normal condition for 30 minutes. | Mechanical and electrical characteristics shall be satisfied. |
| 5F | Salt Spray Test | 5% NaCl liquor for 24 hours, after washing, keep in normal condition for 30 minutes. | No corrosion. |
